Installation guide
How to Install Tesla Wheel Covers
Snap-on wheel covers are designed to be simple, but careful alignment and a final clip check matter. Installation should always be done while the vehicle is parked safely.
Prepare the wheel
Clean the wheel face and remove debris around the clip contact areas.
Inspect the cover and confirm the valve stem opening before pressing it onto the wheel.
Press evenly
Align the valve stem opening first, then press around the outer edge using steady, even pressure.
Do not kick or hammer the cover into place.
Final safety check
Confirm all clips are locked before driving.
Re-check the covers after the first short drive and after any removal or reinstallation.
Need a fitment check?
Email a clear wheel photo to nevesto777777@gmail.com before ordering if you are unsure which cover set fits your Tesla.
Contact Support